|Name||Stretchset Reach Adjustment Headset - 5mm Reach Steuersatz Tapered|
|Produkt angelegt von||Milchbubi1987, 05.09.2017, 13:12|
|Bild hochgeladen von||Milchbubi1987, 05.09.2017, 13:12|
Fit the Reacheriser to tune the effective toptube length of your frame. By mounting the bearings externally we can create an eccentric cup to move the steerer 5-7mm forwards or backwards depending on your requirements. Breathe fresh life into an old frame by tweaking your geometry to improve your handling. This adjusts your effective toptube length which is not the same as fitting a longer stem, as it moves the pivot point of your steerer. Choose from our comprehensive range of fitments, to suit the most common sizes. Fully sealed cartridge bearings and custom made NBR wiper seals keep out the dirt and water, giving you a long lifespan in the worst conditions. An innovative retained compression ring and split crown race makes assembly easy.
New range of high quality headsets manufactured in the UK by Superstar's in house manufacturing facility in Lincoln. Manufactured to the highest tolerances these headsets are a perfect fit and forget, multi-sealed replacement for the cheap and nasty product normally fitted to complete bikes to keep manufacturing costs down.
Complete kits designed for the most popular frame fitment.
This headset will only work with 1 1/8" steerer tube forks (except taper specific model).
Check you have sufficient clearance inside of your headtube to allow fitment, some headtubes reduce in diameter internally and will not work.
We manufacture our headsets to the IS standard set out by Cane Creek. The tolerances are measured in microns, but if your headtube is oversized, ovalised or worn your headset may not function correctly or creak. This is not a fault with the product but a faulty frame.
We reccomend careful pressing with a quality headset press. Allignment lines are engraved into the cups.
Spares available - Topcap Kit, Bearings and Seals
Stack measurements include top cover or crown race.
Note that some manufacturers list cup only to make them appear shorter than they are.
Angle headsets are the mid stack height and will vary by a mm or so depending on angle.
Our headsets are highly sealed with custom moulded wiper seal, this adds approximately 2mm over unsealed headsets but we feel this is essential to long service life.
EC44 - Stack Height 16.5mm – Insertion 10mm
EC49 - Stack Height 16.5mm – Insertion 10mm
ZS56 - Stack Height 8.5mm – Insertion 10mm
EC44 - Stack Height 13.5mm – Insertion 10mm
EC49 - Stack Height 13.5mm – Insertion 10mm
ZS56 - Stack Height 6.5mm – Insertion 10mm
ZS56 TAPER - Stack Height 13.5mm – Insertion 10mm
Durchschnitt aller Messungen
|207.00 g, 0,00 g, 0,00 %|